Corporate News

After about two months of design and manufacturing process, a fully automatic fish feed production line with a capacity of 2t/h is ready to be loaded and shipped. The entire production line occupies 5 containers. After two days of hard work by the staff, it was successfully packed and shipped.

Single screw extruder has no gearbox, one shaft, motor direct start; twin screw dog food equipment, has gearboxl, two shafts, frequency conversion control. The twin-screw dog food equipment is more stable, and the feed/food made is smooth in appearance and has a good degree of ripening.

International Labor Day holiday

Holiday notice

According to different varieties and growth stages, producing puffed floating fish feed that is suitable for their caliber and nutritional needs can well meet the feed needs of conventional aquaculture and special aquaculture, which not only facilitates aquaculture producers but also promotes production development.

With the increasing awareness of environmental protection, more and more people are paying attention to the issue of biodegradable materials.

China Qingming Festival holiday

In the aquatic feed industry, extruders are widely used. The reason is that the materials produced by extruders are diverse and their maturity is higher than that of pelletizers, which causes much less environmental pollution. Many manufacturers generally Only floating materials are produced.

Extruded aquatic feed can be suspended on the water surface for a long time. There is no need to set up a special feeding platform when feeding, just feeding at a fixed point. Fish need to float on the water surface when feeding, so they can directly observe the feeding situation of the fish, adjust the feeding amount in time, and understand the growth and health status of the fish in a timely manner. Therefore, the use of aquatic extruded feed is helpful for scientific feeding management, which not only saves a lot of time, but also improves labor productivity.

The ISO certification audit team came to our factory to meet and communicate about our company's quality management system.